Pass The Hazard Perception Test HPT – Hack

Pass The Hazard Perception Test HPT – Hack

WARNING – FOLLOW THESE STEPS AT YOUR OWN RISK

<!–disclaimer–>

This is a hack for passing The Hazard Perception Test HPT. I take no responsibility if people fail the test as a result of following these steps. These steps should only be taken as a last resort if you have attempted The Hazard Perception Test HPT several times and failed.  The reason I am giving this info away is because in this digital day and age I find the HPT to be a pathetic money grab. If they were serious about this test they would take some funds from those terrifying ads invest some real money and make proper gaming style consoles or cabin style simulators that would feel like the real thing. Instead they give you a 2D 1980’s video clip on a 17″ screen and a mouse.

<!–end disclaimer–>

The Hack:

On every single question/clip of The Hazard Perception Test HPT where you should slow down count IN SECONDS 1,2,3 after the question/clip begins and click the mouse. That’s it! Good luck.

The Vicroads Driving Test Fail For Speeding

Speeding (too fast)

◾During the Vicroads drive test when you see a 60km sign you will do 55km (we always do 5km under the speed limit as a buffer or safety precaution in case of lapse of concentration  or a downhill run so you hopefully go only as high as the speed limit and not over.

◾If you turn into a new street and don’t see any signs you must assume its 50km unless the tester tells you otherwise (for you 45km because you are on a test and we always do 5km under).

◾Permanent 40 – it’s always 40km 24 hours a day, until you DRIVE PAST a different speed sign or turn into a different street (and yes for you 35km because you’re on a test).

◾School Zone 40 – only on school days between school zone hours  8am until 9:30am and 2:30pm until 4:00pm, until you DRIVE PAST a different speed sign.  It is still school zone 40 after turning into a different street until you DRIVE PAST a different speed sign.

◾Roadwork ahead 40 until you DRIVE PAST end roadwork sign or turn into a different street

◾Without getting technical, if you go over the speed limit you can FAIL YOUR TEST. Even just 1km over the speed limit

◾Remember to enter any new speed zone at the correct speed i.e. if you are driving from a 70 zone to a 60 zone you must drop your speed to 60 (55 for you) prior to reaching the 60 sign, passing the sign and then dropping your speed is too late.

◾When going from a slower speed to a higher speed i.e. from a 40 zone to a 50 zone you must DRIVE PAST the 50 sign before you speed up.

Emphasis is put on DRIVE PAST as drivers start to speed up when they see the new speed sign, however you are still in the current speed zone until you physically DRIVE PAST the new speed sign therefore entering the new speed zone. Many people fail their test by getting this wrong.

For full details read our: Tips & Tricks to Passing The Vicroads Drive Test

Cheap Overseas Licence Conversion

Cheap Overseas Licence Conversion

You have  your overseas licence and want to make a quick and overseas licence conversion with a cheap driving test to a Victorian licence. You  know how to drive.         Many overseas drivers  have  been driving in Melbourne for months and some for years. A cheap overseas licence conversion is all you want. Book your test online with Vicroads and contact us for the cheapest overseas licence coversion in Melbourne

The Cheapest Overseas Licence Conversion in Melbourne (9790 0407)

Tips to Pass The Vicroads Drive Test eBook

How do you pass the Vicroads drive test?

What are the tips for passing the Vicroads driving test?

You must understand the procedure of the Vicroads drive test and the different types of instruction given by the tester. What happens in stage 1 and stage 2?

Be informed on how the tester will be assessing you and most importantly …

KNOW THE DO’S AND DONT’S OF THE VICROADS DRIVE TEST – what this eBook is really all about

Overseas Licence Conversion Melbourne Victoria – ID

Overseas Licence Concersion

One of the biggest mistakes for overseas licence conversions to Victorian licence is identification.

The names on all your I.D. must match exactly and in the same order on all documents. So many overseas drivers learn this the hard way when attempting the Overseas Licence Conversion Vicroads drive test.

They are simply rejected on the day and not allowed to do the Overseas Licence Conversion Vicroads driving test. If you are not sure then take your identification prior to the day of your test and ask someone at Vicroads.

Tips – The Vicroads Driving Test Procedure

The Vicroads Drive Test Procedure

  • The Vicroads drive test is split into 2 stages. Stage 1 goes for 10 minutes and stage 2 for 20 minutes.
  • Stage 1 is the easy stage where you will drive mostly in back streets. You will have to perform a reverse parallel parking or 3 point turn. Typically the tester will ask you to do parking unless they cannot find an appropriate spot. You will then be asked to pull over and stop at the kerb where safe and the tester will add up your score. If all is good the tester will ask you to continue with the drive.
  • In stage 2 of the Vicroads drive test you will venture out onto main roads (multilane and high speed roads, major intersections) and amongst heavier traffic where you will be asked to perform turns and lane changes. In some cases the tester will ask you to perform lane changes and in other cases you will be forced to do lane changes due to traffic conditions i.e. parked car blocking your lane or left lane ends merge right sign. It is important you listen to the tester’s instructions and if in doubt you may ask the tester to repeat the instruction.

For more info check our Alex Driving School eBook

Tips – Vicroads Drive Test In Your Own Car?

Vehicles that can be used for the Vicroads drive test

It must:

  • be registered, roadworthy, and clean
  • have both driver and passenger side mirrors
  • have a windscreen demister and a functioning rear window demister (where fitted)
  • have a seatbelt for all occupants
  • be able to maintain a comfortable temperature
  • be fitted with ‘L’ plates
  • have a working primary speedometer (as fitted by the manufacturer). The entire speedometer must be easily visible to the testing officer from the front and rear passenger seat. A supplementary display unit, excluding one that is GPS based can be used **
  • be capable of having the headlights (low beam) turned on during the test
  • be fitted with a centrally mounted handbrake that the front passenger can operate if required. Vehicles fitted with electric or foot operated park brakes cannot be used for solo tests (this is not required if a driving instructor is in the front passenger seat)
  • have doors that can be opened by the licence testing officer from inside the vehicle
  • have normal manual transmission if you want a manual driver licence to be issued.

Going for you Vicroads driving test with a professional driving instructor has its advantages:

  • the Vicroads testing officer can see you have taken professional driving lessons
  • because you have taken professional driving lessons your driving instructor has likely explained the testing procedure and the types of instructions you can expect from the Vicroads testing officer
  • your driving instructor has taken you over the testing routes and although you may not have covered all the Vicroads testing routes you at least have an idea of the format of the driving test

Alex Driving School Melbourne. The highest Google Reviews of all Driving Schools in Melbourne

Tips – Vicroads Driving Test – Speeding – Speed Limits

Check Alex Driving School eBook For More Info

Speeding (too fast)

 

  • During the drive test when you see a 60km sign you will do 55km (we always do 5km under the speed limit as a buffer or safety precaution in case of lapse of concentration  or a downhill run so you hopefully go only as high as the speed limit and not over.
  • If you turn into a new street and don’t see any signs you must assume its 50km unless the tester tells you otherwise (for you 45km because you are on a test and we always do 5km under).
  • Permanent 40 – it’s always 40km 24 hours a day, until you DRIVE PAST a different speed sign or turn into a different street (and yes for you 35km because you’re on a test).
  • School Zone 40 – only on school days between school zone hours
    8am until 9:30am and 2:30pm until 4:00pm, until you DRIVE PAST a different speed sign.  It is still school zone 40 after turning into a different street until you DRIVE PAST a different speed sign.
  • Roadwork ahead 40 until you DRIVE PAST end roadwork sign or turn into a different street
  • Without getting technical, if you go over the speed limit you can FAIL YOUR TEST. Even just 1km over the speed limit
  • Remember to enter any new speed zone at the correct speed i.e. if you are driving from a 70 zone to a 60 zone you must drop your speed to 60 (55 for you) prior to reaching the 60 sign, passing the sign and then dropping your speed is too late.
  • When going from a slower speed to a higher speed i.e. from a 40 zone to a 50 zone you must DRIVE PAST the 50 sign before you speed up.
  • Emphasis is put on DRIVE PAST as drivers start to speed up when they see the new speed sign, however you are still in the current speed zone until you physically DRIVE PAST the new speed sign therefore entering the new speed zone. Many people fail their test by getting this wrong.

Tips – Vicroads Driving Test Roundabouts

The Vicroads Drive Test

Roundabouts

  • When approaching roundabouts on the Vicroads drive test slow down so that you can stop if there are other cars within the roundabout and on your right and that includes the oncoming car with his right signal on.
  • Each roundabout needs to be treated on its own merits as some views on your right are great and other times the view on your right is terrible due to a high fence or wall.  In this case slow right down and press up against your give way line for the best view possible.
  • The roundabouts central island has bushes and the oncoming car has entered but we can’t see whether the right signal is on. Better wait and see.

If you approach the roundabout and all is clear then don’t stop at all as doing so is wrong, simply move along.

Good Luck in Passing The Vicroads Drive Test